Installations Principles | DAMPA DCC 300/200
The DCC 300/200 Ceiling Panels are designed to integrate with all types of partitions.
The Basic Principle | DAMPA DCC 300/200
The Basic Principle uses Edge Trim No. 13 or DAMPA Top Profiles at all perimeters.
Suspension hangers and Modular Carrier No. 16 provide the ceiling support.
Reduction in Hangers | DAMPA DCC 300/200
Reduction in hangers can be achieved by providing alternative support at panel ends. This can be achieved by using Angle Runner No. 29, alternatively Modular Carrier No. 45 secured to DAMPA Top Profiles.
The maximum distance from wall to first carrier can be increased from 300 mm to 1200 mm. Otherwise, the Basic Principle applies.
Corridor Ceiling without Hangers | DAMPA DCC 300/200
Corridor Ceilings without hangers are possible in areas with widths less than 1250 mm, by using Angle Runner No. 29,
alternatively Modular Carrier No. 45, secured to DAMPA Top Profiles.
Installation & Dismantling | DAMPA DCC 300/200
The DAMPA DCC 300/200 Ceiling Panels are normally installed progressively, starting at either end of the room. However, panels can be left out at any position to be installed later.
Fire rated ceiling panels are installed with a self-tapping screw at each end.
Access to the ceiling void can be achieved at any point within the ceiling area, as each panel is individually demountable.
Access to the ceiling void can be achieved at any point within the ceiling area, as each panel is individually demountable.
